Wiring

Finally had the pots for starting wiring the guitar.

Fender A250k pot for the volume control and 2 Harley Benton Push Push A250k pots for the tone controls.

The wiring plan more or less…

Lets begin the soldering and wiring mess.

In order to not have problems with controls in the plate i put it on top off 2 small wood bars so that the scratch plate is not resting on the input controls.

So lets solder.

I also decided to had a the mod that allows to use the Bridge plus Neck and all pickups at the same time.

After all wired up i temporally connected the plate to a used input jack and plug it into an amp to test it, its working.

In order for the plate to fit the body the cable need to be properly secured in the right places, so i isolated the soldered ends and organized the cables.

The cables not organized did not allow the plate to sit on the body.

Now the plate fits the body.

This is how the plate it self looks with all the controls.

I already wired the input jack and the ground connection on the tremolo, just did not connected to the scratch plate, i will leave that unplugged until the neck is ready, allowing me to do any alteration that might need to be done and i will need to adjust the length off the cables from the input jack since they are at the moment making not possible to place the plate since the space for cables is a bit low, i will need to make that cable small enough so that the plate rest perfectly but to allow in the feature if needed to remove the plate without cutting the cables.